I just installed my new Juice/Attitude and (EGT) thermocouple. Will admit was a little nervous about tapping and drilling the cast iron exhaust manifold after reading the thread by Leo(CntrlCaldmax) with his troubles. All went very good though. I did tap it a little deeper than I intended too, had to run the fitting all the way in to get it to tighten. As old and blind as I am it's lucky it turn out as well.


I want to thank all on the Diesel Place for the information that helps us to be able to do these projects.


Ridge Runner

Glad everything went ok for ya, They get much easier (and less nerve racking) after you wear out a few taps....

yes eric you're right.. i've done a few and get less nervous each time...