This is an easy one.
What is the size of the fuel line between the filter and injector pump and about how much would I need to replace all of them? I have a leak down there somewhere and am just going to replace everything.

Thanks.

1/4 inch I.D.

To do both you will have a little to spare if you buy 5 feet.

Simple to change, what i did was taped the new to the old and pulled them through the loom, leaving the loom in place under the intake so as to avoid having to fish around in there too much.

Make sure you get fuel line hose, not gasoline.

Dont over tighten the hole clamps too much. It will damage the hose and eventually leak. Also, while your in there you might as well do this:


http://www.dieselplace.com/forum/sho...ding+the+beast (http://www.dieselplace.com/forum/showthread.php?t=42291&highlight=feeding+the+beast)

Yes, feed the beast. Turbine Doc was dead on with this mod.