I currently have the juice on 90 and the superchip on stage 2. I didn't remove the edge when I installed the superchip, and had no problems. Now I want to back out the superchip so i can run the hot juice. Do I have to remove the edge 1st? Just asking b/c I was told that it might lock up the vin # in the superchip if I don't remove the edge.

I have never had a problem with doing that, but not to say you or somebody else doesn't. If your worried, pull the juice, it only take 30 secs.

DITTO

I have never had a problem with doing that, but not to say you or somebody else doesn't. If your worried, pull the juice, it only take 30 secs.





You guys must be young.


It takes me more than 30 seconds to just crawl upon the engine. Then of course I have everthing tie straped down, so you have to cut the straps. And of course you know atleast one of the damn harnesses will be stuck, so you have to get something to try and pry the that harness apart. etc etc. "Murphy" (law) is always in my garage http://www.dieselplace.com/forum/smileys/Ermm.gif

4 minutes to change an ECMhttp://www.dieselplace.com/forum/smileys/Approve.gif practice makes perfect

4 minutes to change an ECMhttp://www.dieselplace.com/forum/smileys/Approve.gif practice makes perfect

hot or cold? and how long to swap your juice?

Thanks for all the feed back.