gmclly20054X4
03-06-2006, 07:20 PM
i like to know how hard it would be to put a lift on my truck? i know how to work on truck iam not totally dumb i help 05lly2500hd which is my nepw put his twins on his truck ty for any input
|
OneTALLGMC96 03-06-2006, 08:05 PM Not all that hard, just a bit time consuming. If you go with a spindle-type lift, your front trac width will be widened, but you won't have to cut anything (Certain skyjacker and procomp lifts...that I know of). You should more than be able to tackle it with the right tools and some knowledge. ockgator 03-06-2006, 10:03 PM GET THE CORRECT BAR UNLOADING TOOL cannot emphasize this enough Most of the brand name kits aren't too bad, most all have good instructions w/pics. I know for sure that the rancho and pro comp kits need few pieces cut off, sawzall works perfectly. Most with a bit of mechanical ability can do one in a weekend, the front parts are heavy.... don't attempt lifting them alone OneTALLGMC96 03-06-2006, 10:08 PM I have used a two-jaw gear puller several times, but it made me more and more nervous every time...get the tool! _nar_ 03-06-2006, 10:28 PM If you have decent mechanical skills you can install a lift, it isn't that hard, just takes a while... gmclly20054X4 03-08-2006, 12:09 AM kook ok ty yall what tool was yall talken about were do i get ? hardcoremxer7 03-08-2006, 07:04 PM The torsion bar will fall right out if you unbolt everything from the lower control arm and leave it connected to the truck and step on it. Give a lil yank and it will slide right on out. You don't need any tool bow-tie-guy 03-08-2006, 10:40 PM Have you checked with Superlift to see what they have? gmclly20054X4 03-09-2006, 02:45 PM have not check did not know is i was going to use them or not | ||