|
Goalnightx 02-27-2006, 12:53 PM I have the PPE Hot box on my 05 LLY. Suncoast level 5 tranny will be added in the next three to four weeks. (I have been running the 130HP tune with no problems on the stock tranny) When I go to run the 180 or 240 tune what, besides the tranny, will I need on the truck in order for it to operate smoothly? Will I need the shim mods? Or do you wait to see if any codes get thrown? I am also considering the +2 upgrade as well. Thanks in advance. G McRat 02-27-2006, 01:18 PM Lift pump, shim mod, gauges, boost controller to clean up the smoke. McRat 02-27-2006, 01:19 PM PPE has a new LLY Tune out that I haven't tested yet. Mark ran it at the track yesterday and it did very well, but I forget the ET. Goalnightx 02-27-2006, 02:53 PM Lift pump, shim mod, gauges, boost controller to clean up the smoke. Should I get the shim mod done prior or wait until it throws a code? Or does running the 240 tune create an automatic 1093? Gauges and PPE boost controller will be done for sure. Thanks McRat Goalnightx 02-27-2006, 02:54 PM PPE has a new LLY Tune out that I haven't tested yet. Mark ran it at the track yesterday and it did very well, but I forget the ET. Is this the 290 HP +2 version or another PPE LLY product all together? Thanks McRat! McRat 02-27-2006, 03:00 PM You can wait to see if you P1093 then do it. You'd have to ask PPE or a PPE dealer what's going on with the new tune. I just heard about. I'm not a PPE dealer, I just help them develop stuff when I can. baxterboy 02-27-2006, 03:58 PM Looking at doing this same thing and taking off my edge juice. What is a shim mod? Will this still happen with a PPE +2 program? Have prepared for everything except this shim mod. McRat 02-27-2006, 03:59 PM Do a search. I did a writeup on how to do the Shim Mod. It will stop P1093 error codes and loss of power. | ||