PeteDrez
02-09-2006, 11:46 AM
Have some questions on the suspension measurements. The truck is three weeks old and could not be better. Makes me think I should just leave it be. But that is no fun so I decided that I would try to level it. After much help from DP members, I crawled under to see where the keys were to adjust the torsion bars fully expecting the adjustment bolts to look similar. What I found was the passanger side bolt chanked in significantly more than the drivers side. See the attached pictures. Anyone with the original factory settings with a similar situation? Also, any thoughts on this being a problem or not? When I measured the hieghts of all the wheel wells, ground to inner edge of the wheel wells, I did get a difference there also. The numbers are: passanger front 38.125, drivers front 37.75, passanger rear 41.75, drivers rear 41.0 The net is the passanger side is higher and this is the side the key bolt is screwed in further. It just looks like a big difference in the bolt adjustments for a little difference in hieght. I would appreciate your suggestions and experiences on this, to get me a little better educated before I put the socket to it. BTW, the fuel tank on the drivers side is a little less than 3/4 full. Thanks