I just had my gauge cluster replaced because of a faulty speedo and now I have no fuel filter life monitor on my DIC. I had the reflash for surge and the fuel filter life monitor back in Nov. and then had the new one (for surging)released on 11-18-05 done a couple of weeks ago. How do I get the fuel monitor back on my DIC? I don't know if you can get the old reflash done again or what. Will doing this screw anything or any other reflashes up by overwriting them? By the way the reflash released on 11-18-05 for surging worked awesome. Truck is much more enjoyable to drive.
Also now my oil pressure when cold will almost go up to 120 psi. It never did this before. At idle after it is warm is a little above 30 which is fine and little above 60 after warmed up at 2000rpm which is fine. But my old cluster never went that high before. Maybe 90psi cold, warm idle-hair below 30 and warm at 2000rpm hair below 60. Now the new one is all different. Is this normal? Is it because my old cluster was junk and the new one is more accurate?