my display disapeared on my atittude havent looked if it is unpluged . we put the chip box inside the fuse container so i havent taken it apart yet. just wandering ifany body had this happen to them

if you place the chip box in the fuse box,it's probably heating up...no air..my display was freezing up during hot summer days...my chip was on top of the fuse box...so i move it to the top of the engine so the fan air could hit it..and it's fine now...

My Attitude screen won't display until the cab begins to warm up if air temperatures are 10 below or less - is it cold there?

no its not coldhere its been for 25 days one more day itll be a record since the 50s UGHHH also the lite is strill on the buttons so thier most be power thanks for the repliese

no its not that cold here its been raining for 25 days a record since the fiftys the light s are still on the buttons so thier most be power

There's power and the display is backlit and "trying" to show at deep cold temps, the liquid crystals just can't display. It's kind of weird, because the display slowly evolves from a "shadow" as it warms up.

moving to LB7 Electronics

Mine does this at times also, not temperature related. I thought it was from the plug from the box to the attitude monitor needed a small push in. It would light up, with a backlight, but light lettering that would fade away. Mine hasnt done it in a while now, but last spring it seemed like it did it quite often. Hope this helps.

Had the same experience ~ not temp related. After a bit even the button lites were gone.

Did the peddle dance and the juice functioned as it should w/o a controller. Called Edge ~ sent me a new monitor. Developed a startup issue and called Edge again. They shipped an upgraded unit and now me be happy.

thanks guys just got back from a few days away . i will look at it later and try the plug . if its not that i will have to get a hold of the company