Wondering if anyone has removed the pass. side manifold on one of these trucks? Looking at all options for installing the egt probe. Will probably follow the route most of you have, but would like a back up in case of a problem.

Thanks,
John

Try The New Bd Power Manifold It Has An Egt Port

Also The Bd Power Website Has Detailed Removal Instructions

drill it and tap it yourself. just make shure it's clean when you install. 45min job.

start the truck and let it idle while drilling, go slow and you'll be fine

i took mine right off. better to be safe than sorry. the gaskets are reuseable. it really is a piece of cake

Wondering if anyone has removed the pass. side manifold on one of these trucks? Looking at all options for installing the egt probe. Will probably follow the route most of you have, but would like a back up in case of a problem.

Thanks,
John

John, welcome aboard. In all honesty it will take you longer to remove the manifold than it will to drill and tap it through the fender. I did mine in about 30 minutes and it was my first time doing it as well. Take your time and make sure you have all the exact tools you need. I followed the instructions in the Edge manual for mine. Worked like a charm.

i removed it, drilled/tapped it, and reinstalled it in about 45 mins. remove the inner fenderwell and its so easy i wouldnt think twice about it