Is anyone with the AFE stage II getting ses codes with this setup..My Air force one gave me codes because I believe the maf was moved inboard at least 12inches.Stock box back on and no codes.. Would like to have a nice looking intake but on mine the maf position is real touchy...not sure why it matters were the sensor is located..

I installed one on friday, no trouble yet. I think that relocation of the MAF sensor has been documented here as a code setter.

I've had one since October, and have only thrown one code since, but it wasn't caused by the AFE.

I have not had any problems with mine. I have had mine instaleed for about a month and half.

I have been getting an overboost code about once a week, dont know why? I have the afe stg 2 but I dont think that is causing it. It does it without any performance boxes added, and the computer was updated in October.

I also installed my aFe Stage II in October... No problems at all.








Kevinhttp://www.dieselplace.com/forum/smileys/Big Smile.gif

Installed mine in December. No codes yet.

No Problems since a December install. Could it be a heating problem that is initiating the code?? Just a bit of brain gas I had.

Thanks guys..Looks like the AFE stage II is the way to go.

The code issue is why I bought the AFE instead of the K&N. Two weeks and no codes, knock on wood. So far on the first tank I've picked up 1 mpg, and that turbo sound.http://www.dieselplace.com/forum/smileys/Clap.gif 19 mpg commuting, which is 1/2 freeway, 1/2 surface streets.

Installed for over a year, no problems...

Installed in August without any codes.

Installed last July....no codes.

Got my first code last night. 0101. "Mass or Volume Air Flow Circuit Range/Performance Problem"


Leaving work about 9pm. Truck was cold....just cruising along nice and easy and BAM the SES light pops on. Cleared the code and been fine today.