Well, got my Edge Juice and Attitude installed. All I got to say is WOOHOO! Just running level 2 but going to back down to level 0 until I get the EGT hooked up this weekend.


Is it normal to have one heck of a wire mess after you install this thing. I would guess that it is. I had to undue the plastic clamp holding the ECM wiring harness in place just to be able to cram all the crap in there so that I could get the connectors hooked up. Should I tie them in place at all? What have other people done?


Thanks.


Curtis

I dont think it is necessary to tie the wires back. its not the cleanest install with all the wires, but you cant argue with 125HP.

I installed my Juice /Attitude combo yesterday, Followed Hoot's directions for the EGT probe install all went smooth. The increased powere is great, but im afraid to stomp on it in level 5 dont wanna brake the trannyhttp://dieselplace.com/forum/smileys/Big%20Smile.gif I left the wires unsnapped too.Edited by: kg208

KG208, Nice to see somebody on here very close. I am located in the Round Lake Beach, IL. area. I got my Juice/Attitude installed but have the task of installing the EGT probe this weekend. Should be fun...


Curtis

The install should not have been a dirty one at all, those are the most basic ones to install, I mean they have the least amount of wires and junk. Though the under hood connectors can be tight at times, no worries they will lossen up a bit after a while!!!!http://www.dieselplace.com/forum/smileys/Approve.gif