Hello everybody, I know this has been discussed before but I cannot seem to find the articles. I just got my Juice with Attitude today from the big brown truck.


I installed the Attitude using the ATS mount in the overhead and ran the wire through the headliner and down the drivers side pillar and it is currently residing in my fuse panel by the door wound up. My question is how did people get it from there to the engine compartment?


I have one other question as well, I bought the 3' extension but am also thinking about putting a plug behind the overhead so that when I take it into the dealer I can just unplug it and remove and leave the wire in place. Has anybody done this or does anybody see a problem with doing this?


Hopefully I will have this all up and running by this weekend so that I can see what kind of Juice I get! Should make for more fun turning those 285's as well...


Thanks.


Curtis

There is a rubber grommet with some wires going through it on the firewall under the steering column. Just push a piece of wire through the grommet, tape your cable to one end, and push it to the other side.


Jesse

Hello everybody, I know this has been discussed before but I cannot question as well, I bought the 3' extension but am also thinking about putting a plug behind the overhead so that when I take it into the dealer I can just unplug it and remove and leave the wire in place. Has anybody done this or does anybody see a problem with doing this?











Why not just push the Additude in side the cubby and put the factory front back on ??


Once you cut the wires if you have a problem with the Additude controler or box itself ,well ,Edge is compromising but I bet the draw a line at that ....





Mac http://www.dieselplace.com/forum/smileys/Confused.gif

I guess I could just push it back inside but the 03 has that little cubby up there. Guess I could push it inside and put the cubby back in place. Kinda a pain in the rump but if it is what I got to do then that is what I have to do http://www.dieselplace.com/forum/smileys/Cry.gif


Thanks.


Curtis