there were a couple mods that need to be made but I expect this to be corrected in less than a week.

http://www.dynadroitclutches.com/

Installation instructions are will be done soon:

read post #17

http://dieselplace.com/forum/showthread.php?p=782094#post782094

The flywheel will show up tomorrow. IT will be modified a bit so I will take some new pics.

Flywheel is being re-milled, again. Each time they change it gets closer and weighs less! Saturday will be another SBC adventure!!

My clutch website has been updated and provides more information. I will get the pictures changes eventually.

Here are some pics of the prototype kit installed last Saturday:

The production units, already underway, will be very similar. The red paint is for alignment of the flywheel, floater plate, and pressure plate. The clutch plates have stickers which indicate which position to install. The kit will come with an alignment tool. I have almost completed the extensive installation instructions which includes quite a few pics and tips.

My website will have a few minor mods and a shopping cart, hopefully, by the end of this week.