I'm tring to locate the wiper module on my 2002 chevy silverado 2500 HD Duramax.


Please help, I am replacing ASAP


Thanks!


P.S. please post reply I do not have access to my e-mail at this time.

try ebay. There are lots of trucks being parted out on there.

It's under the air grill below the windshield.


<A href="http://service.gm.com/servlets/BlobShtml?ShtmlFile=773616#oth1-773616" target="_blank">
<H4>FIGURE Left Rear Underhood - Front of Dash(c)</H4>


</A>
http://service.gm.com/engif/000/000/310/310036.gif
http://service.gm.com/tif.gif (http://service.gm.com/servlets/RetrieveTif?pic=310036)
<MAP name=310036.map>
<TABLE>
<T>
<TR>
<TH align=left></TH></TR>
<TR>
<TD align=middle>(1)</TD>
<TD align=left>Windshield Wiper Motor Module Electrical Connector</TD></TR>
<TR>
<TD align=middle>(2)</TD>
<TD align=left>Cruise Control Module Electrical Connector</TD></TR>
<TR>
<TD align=middle>(3)</TD>
<TD align=left>Plenum Panel</TD></TR>
<TR>
<TD align=middle>(4)</TD>
<TD align=left>Cruise Control Module</TD></TR>
<TR>
<TD align=middle>(5)</TD>
<TD align=left>Pass - Through 100 (P100)</TD></TR>
<TR>
<TD align=middle>(6)</TD>
<TD align=left>Dash Panel</TD></TR>
<TR>
<TD align=middle>(7)</TD>
<TD align=left>Cap For Connector, Without Cruise Control</TD></TR>
<TR>
<TD align=middle>(8)</TD>
<TD align=left>Cruise Control Module Electrical Connector</TD></TR>
<TR>
<TD align=middle>(9)</TD>
<TD align=left>Harness - Pass Through</TD></TR>
<TR>
<TD align=middle>(10)</TD>
<TD align=left>Windshield Wiper Motor Module</TD></TR></T></TABLE></MAP>

Looks like I read your post wrong. http://www.dieselplace.com/forum/smileys/Confused.gif

http://www.dieselplace.com/forum/smileys/Big Smile.gifMan that was fast, thanxs so much for the help.http://www.dieselplace.com/forum/smileys/Clap.gif You have just saved me hours of looking around for that.


Thanks Again


Matthew

This may sound stupid but after taking the nut off the wiper arm, how do the wiper arms come off?http://www.dieselplace.com/forum/smileys/Angry.gif I've been tugging on them and don't want to break them if there is a special way they come off.


Thanks


Matthew

Pry, tap with a rubber hammer and pry some more.

I just pulled mine off tonight to gain access to the motor.


I loosened the nut to where the end of the threaded post was protected then tapped on it with a hammer until the arm jarred loose.


No fear of damage.

Thanks everyone for the help. I just got home after installing the new wiper module. Thanks to the help from you guys the install was succesful.http://www.dieselplace.com/forum/smileys/Clap.gifhttp://www.dieselplace.com/forum/smileys/Big Smile.gif


Thanks Again


Matthew

WOW!http://www.dieselplace.com/forum/smileys/Shocked.gif SWEET TRUCK!

somedayadiesel




It wouldn't let me pm you. How you like the site. Pretty sweet huh.


See ya soon