Hey im picking up my 06 in a week, im looking on da net 4 computer programers to re program the computer, anyone have suggestions ?
dont want a selectable - on dash programer.
thinkin of adding a aft mkt exhaust and k and n filter, o yea and wheelie bars
thahnks Rick
wahlrite

there are no programmers/tuners available for the 06 yet. do you know what motor its going to have? LLY or LBZ?

..and moving to LLY Electronics section.

I dont think K&N makes an intake for even the 2004.5-2005 LLY...much less the 2006 LLY. But I would leave your stock intake alone. The 2006 intake is a cold-air-intake I beleive and is a very good setup. You would probably not see any gain with an aftermarket intake. I dont know if any aftermarket guys are making an exhaust for the 2006 yet either...and of course, as Briano said, there are no computers/programmers for the 2006 yet, and if your truck is an LLY, they may never make chips for it unfortunatly...

---Ben

TTS, and I believe Banks, have taken measurements on the '06 and are working on getting one ready for market.
The TTS will be a 4" cat-back with a straight muffler design that's no louder than stock.

K&N does make a panel filter for the 4.5-5 LLY, but per the tests that were run on a bunch of filters by someone on this site, it was determined that it let too many particles in and the stock filter flowed just the same if not more while blocking tiny particles.
As far as the 06 LLY and LBZ, I have no idea if there is a filter, intake kit, or programmer available..although some are in the works it sounds like.

I had a 06 LLY in the shop this week. Sent the PCM to Bullydog and had it reflashed. It did 460hp 900 tq on a Mustang 1750 dyno. The reflash and FASS 95 gained 150 hp.

Cough.......Cough..........