|
: Anyone ever replace the mirror glass on the outside mirrors? ’03-’04 GMC? HD-Nate 09-01-2005, 02:07 PM Anyone ever replace the mirror glass on the outside mirrors? ’03-’04 GMC? Have a crack in the mirror on the right side, I have the GM replacement glass but not sure how to remove the old, install the new? Anyone done this before? Thanks! Max Power 09-01-2005, 02:11 PM Power extending mirrors? There is a clip you need to release at the bottom center of the glass on the inside. If you tilt it all the way up you should be able to see it. Then the Glass slides up or down, can't remember. HD-Nate 09-01-2005, 02:13 PM Power extending mirrors? There is a clip you need to release at the bottom center of the glass on the inside. If you tilt it all the way up you should be able to see it. Then the Glass slides up or down, can't remember. No, they are not the extending mirrors, hopefully they are the same? Max Power 09-01-2005, 02:15 PM I'll look. Duratys 09-01-2005, 02:20 PM Power extending mirrors? There is a clip you need to release at the bottom center of the glass on the inside. If you tilt it all the way up you should be able to see it. Then the Glass slides up or down, can't remember. Off topic as he does not have these mirrors......but for the info in a search, the glass will slide up. Max Power 09-01-2005, 02:24 PM Mirror Face Replacement Removal Procedure Caution When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury. Important When removing electrochromatic glass that is broken, or if glass breaks during replacement, be cautious not to spill electrochromatic fluid on to vehicle. Doing so will cause damage to the vehicle. Adjust mirror face as shown in picture to obtain access to mirror face retention clips(1). Position flat-bladed tool between back side of mirror face and the adjuster mechanism as shown in picture. With a twisting motion of the flat bladed tool, separate the mirror face from the adjuster mechanism by releasing the mirror face retention clips(1). With mirror face in hand, disconnect the electrical connectors. Remove the mirror face from the mirror housing. Inspect the adjuster mechanism for damage. Installation Procedure Inspect the components for any damage. Ensure that the mirror face has all the retention clips in place. Plug in the electrical connectors to the back of the mirror. Align the mirror face retention clips with the adjuster mechanism. Gently press the mirror back into the adjuster mechanism with the palm of the hand on the center of the glass until it locks into place. Inspect the operation of the mirror. TheBac 09-01-2005, 02:34 PM Just one word of caution...you may break the mirror glass while removing it. MrsSpoolin 09-01-2005, 06:45 PM When I had to replace one of ours (my fault), I just broke the rest of the glass and removed it so I wouldn't have to worry about it. It's pretty easy to do, took me about 5 minutes, if not less. HD-Nate 09-01-2005, 07:30 PM Outstanding Tony.:thankyou2 Thanks all for the help! Nathan | ||