|
wyattroa 08-26-2005, 03:47 PM I was wondering if you guys with the edge and attitude put the EGT probe in yourself? If you didnt where did you go, i just dont feel comfortable drilling into the manifold myself. anyone in the chicago area that might be willing to help me out? robert Scotty Seelen 08-26-2005, 04:22 PM My dealer did it for me. Idle_Chatter 08-26-2005, 09:17 PM It's not so bad, really. I installed the probe for my Isspro A-pillar gauge in the passenger side. I installed my probe for the Attitude in the bottom of the driver's side. The cast iron of the manifold is really soft and easy to drill (small hole first, then the correct bit for your tap). The trickiest part is the tapered pipe tap in the thin manifold. Take your time, back it off to cut the chips often and DO NOT go deeper that about 1/2 to 2/3 up the tap. All in all, it takes about 30 minutes to do the job slowly and carefully. SaguaroKid 08-26-2005, 09:39 PM Have you seen this in the DYI? http://dieselplace.com/forum/showthread.php?t=892 boatcruiser 08-27-2005, 08:33 AM Did it myself using the HOOT METHOD. No big deal. wyattroa 08-28-2005, 02:36 PM Did it myself using the HOOT METHOD. No big deal. hoot method?? robert Max Power 08-28-2005, 02:44 PM Hoot Method (http://dieselplace.com/forum/showthread.php?t=892) bigblackdmax 08-28-2005, 10:08 PM If you tell us where you are at there might be a member willing to help you do it. wyattroa 08-28-2005, 10:45 PM If you tell us where you are at there might be a member willing to help you do it. Im in lombard,IL... about 30 minutes west of chicago. robert | ||