Hello I am getting ready to Buy a PPE Hot +2 from one of my buddies, I currently have an Edge Juice with ***. I want to run The edge on level 0 and just use the monitor for gauges and use the PPE for my power adder.

I have searched all over the net and cant find a Stright forward answer.... some say yes and some say no.

My Question is Does the edge Juice with ***. add any timing on level 0?

I want to make sure everything is safe just using the juice with ***. for gauges I dont want to add the ppe if the edge makes any timing changes on level 0. Thanks for any help to anyone who may know for sure.

Personally I dont see why the edge would change timing on a Stock setting but I want to confirm this.

yes it does. found it several times with a quick search.

if you are going to stack the two then you need to disable the timing adjustment on the PPE program.

if you just want gauges get an Edge Insight or whatever they're called.. that's what it's for.

From what I have heard from Edge Products they do not add anything to level zero. That is completely stock.

unless Edge changed it in their newer products, they do modify timing only in the stock setting on the older units.. that has been known for years, but I can't verify the newer units. there are stacking posts where people put edge over ppe and everyone says to remove timing from the ppe due to edge adding it in stock mode.

unless Edge changed it in their newer products, they do modify timing only in the stock setting on the older units.. that has been known for years, but I can't verify the newer units. there are stacking posts where people put edge over ppe and everyone says to remove timing from the ppe due to edge adding it in stock mode.

Not trying get into a pissing match, but I have talked to the Edge products design guys. I have always heard "we do not add timing in the stock setting. Stock is stock."

When guys used to stack they did not leave them on the stock settings. They did it for power.