I dont like the stock LS flares. I have been looking for the $$$$ on the painted ones. Does anyone have any sugestions?

I dont like the stock LS flares. I have been looking for the $$$$ on the painted ones. Does anyone have any sugestions?


I've seen lots of painted sets on eBay ... might be worth a shot.

I have a set of factory fender flares that are painted the dark gray color. My intention was to have them painted black like the rest of my truck. I have now given up on that idea so I am willing to sell them. They are in perfect condition, but will need new 3M double side tape. It can be applied after the color change.Any takers ??


Mark

Bushwhacker (sp?) makes aftermarket fender flares.

BLACKDMAX,

What are you going to do for flares once you sell your stock ones??





BobEdited by: bowtiebob

Bob,


The stock black grained flares are still on my truck. These were going to be painted gloss black and replace the ones i have on now.


Mark

These seem a little pricey to me but here are some flares:


textured:


http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=2459643924&category=33 654


paintable:


http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=2460422702&category=33 654


http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=2459805089&category=33 644


http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=2459805122&category=33 644

http://www.dieselplace.com/forum/uploads/53C_truck03.jpgHere's some pics of the flares I have on my 1/2 ton, there made by XENON


http://www.dieselplace.com/forum/uploads/4AC_truck02.jpg

I'm using the Bushwhacker Cutouts. They protrude from the side of the truck about 4". I doubt very many of you guys need that, but from what I experienced with Bushwhackers, they're very simple to install and will fit perfect to body contours!!


Prices are a bit high, but worth it in my opinion.