Ok I must be an idiot, but I followed ProComps instructions for remounting the brake like and abs sensor wire, but my tires rubbed the abs wire on both side, and now they are damn near cut through.

How big of a pain is it to replace those wires? And is there a good way to mount them?

anyone?

For the bottom side you need to remove the brake rotor and the backing plate, them remove the allen head bolt holding it in. For the top, just unplug the lead at the plug.

ok kinda what I figured for changing it, but does anyone have any recomendations on moving it so it doesn't get snagged again?

Here's a pic of how mine is run.
http://www.hotboatpics.com/pics/data/500/5495shockhoops.JPG

Hard to see but it hugs tight to the upper a-arm towards the front of the truck and then up along the frame and under the fender skirt. Not sure how the extra length was achieved, but it looks like they traced the wire back and got the exta slack from the engine bay area, either that or they cut and spliced in a short peice.