hey guys,

I just installed the juice tonite, really woke 'ole red up! I am unsure how to lay out the harness after it has been hooked up to the juice.....Now it's laying on top of the intercooler pipe on one side and on the top rad. hose. Is this ok, and can you please post pics of how your installations look...
thanks
beaver:ro)

Thats how mine is laying also.

Jason

please, need some pics

I'm also getting a rattle at let-off and I guess it's maybe the harness connector thats laying on the intercooler pipe?

need some help please!

beaver:help: :help:

ttt

Should be OK. That is how mine sits. Not much you can do to change the routing of the harness and connectors.

Click on my garage link... there is a picture in my garage.

My Edge EZ unit just sits on the recessed side of my electrical/fuse box which is in the lower right corner of the picture. I used some duct tape to secure it (the tape runs up and into the fuse box, but you cannot see it because the lid is on. Note that the Edge EZ unit is braced/wedged underneath the curved bracket-- the duct tape just provides some extra protection. The switch and switch wire are wrapped around the curved bracket (I haven't installed in yet, and not sure if I am going too). --Paul.