Where should I go to get intake couplers, tubing, and an adapter for my MAF sensor?

Just do the PPE stock box mod it's free and want cost you a dime. Just need a dremel or cut-off wheel and get to cutting.

I have a K&N intake right now im going to be buying rickdlances cold side pipe soon and that will allow me to have more room to make an intake with less bends in it.

Where should I go to get intake couplers, tubing, and an adapter for my MAF sensor?

www.intakehoses.com (http://www.intakehoses.com)

Rick Lance installed my MAF mounting boss in the aluminum tubing.

I checked on there already and didnt see and MAF adapters.

Don't know if you found what you were looking for but this is what I did.
I bought a lot of 4in mandrel bend tube piece from this guy on ebay.

http://cgi.ebay.com/ebaymotors/10-Assorted-3-00-ALUMINIZED-EXHAUST-MANDREL-Bends-Tube-_W0QQcmdZViewItemQQhashZitem4aa5affcb3QQitemZ32060 7354035QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccesso ries

The link I have is for 3in but if you send him an email he should have 4in ones to.

It worked out great for me.

For the MAF sense all I did was cut the plastic piece in the factory tubing, drilled a hole in my 4in tube, then put some sealant and bolted it to the 4in tube. I have had no problems with it at all so far.
I have pictures of it in my garage for more clarifications.

yellowchevy