Hello I just flushed my brakes with a Motive bleeder and 2 quarts of Amsoil DOT3. However I was still getting pretty dirty fluid our of the lines when I used up all the fluid. My master cylinder fluid also still looks black.

Should I flush again?

Did you suck the majority out of the MC first? I usually do that, then fill with new, then start with the bleeding. I would say if you didn't, I would probably redo using that method!!!:beerchug:

No I did not. I just order new fluid I am going to do it again.

That will take care of ya!!!!!

My fluid was first black then it turned to yellow fluid coming out, was the yellow fluid the new fluid? I noticed the AMSOIL fluid when pouring in was clear.

It will be pretty difficult to get it "clear" 100%. You also have to remember that there will be a little old fluid in the ABS module, etc.- unless you have access to a Tech II to get it to go through the cycling there. If you suck out all of the old and go around to each wheel and get a couple of pumps out of each one you should be all right!!!!

I sucked out the old first, filled with new, then bled until the fluid changed colors at each wheel. I only used about a quart and a half.