dmtcm
07-12-2010, 05:37 PM
I have spent alot of time searching the site for the correct pins to use on a 2006 LBZ for the high idle mod.
I finally found them and they are correct.
Tell your GM dealer that you want Tray #19 and pin number 1928498135 in the tray slot #23.
If you're going to solder them in, I recommend you get a few of them. As for myself, I trimmed the wire back about 1 inch and soldered the wire solid. I trimmed the tabs that splice the wire to the connector off clean and then soldered the wire to it without any excess build up. They slid into the connector smoothly and the excess wire is covered by the connector terminal block. Pins number 8 and 60 are correct. Using a toggle switch or equivalent, supply 12 volts to both wires when idle up control is wanted. Turn the switch off before driving. Done Deal !!:D
p.s. Yes, I know my details say 2007, the engine is a 2006.
It was manufactured that way.
I finally found them and they are correct.
Tell your GM dealer that you want Tray #19 and pin number 1928498135 in the tray slot #23.
If you're going to solder them in, I recommend you get a few of them. As for myself, I trimmed the wire back about 1 inch and soldered the wire solid. I trimmed the tabs that splice the wire to the connector off clean and then soldered the wire to it without any excess build up. They slid into the connector smoothly and the excess wire is covered by the connector terminal block. Pins number 8 and 60 are correct. Using a toggle switch or equivalent, supply 12 volts to both wires when idle up control is wanted. Turn the switch off before driving. Done Deal !!:D
p.s. Yes, I know my details say 2007, the engine is a 2006.
It was manufactured that way.