dspeer75
07-09-2010, 09:25 AM
...pics. Anyone have some good pictures of their behind the bumper setup and how they did it?
|
markarnold 07-12-2010, 12:59 AM ...pics. Anyone have some good pictures of their behind the bumper setup and how they did it? No pictures but It was easy to do. Mine is right behind the bumper between the nostrils in the bumper. I bought an L-bracket from Lowes that I found in the joist hanger section. I used small bolts, nuts and washers to secure the bracket to the plastic piece behind the bumper. Then I drilled holes and threaded them in a heat sink I got from a computer repair shop and screwed the PMD through the L-bracket into the heat sink. I bought a 6 ft PMD extension off the web. I hope this is helpful. Mark JMJNet 07-12-2010, 09:45 AM PMD is non-moving parts. You can just fasten it to anything in the bumper and connect the cable. Make sure you put the resistor in it. donaldcabral 07-12-2010, 08:45 PM i dont have a resistor..what is the diffrence? | ||