Hey guys, I was towing a fairly steep hill yesterday and had my Banks set to 3. I got into it a little bit and noticed a sudden drop in performance and a Check Engine Light. The truck still ran fine, but I knew the programmer wasn't working. When I got back home I cycled the key 3 times and in the odometer guage got the code "P 0088" to pop up. Come to find out that it is Fuel Rail Pressure to High. I was curious if any of you have had this occurance. I have towed the same hill before with the same load and setting and never had any problems. The only difference was this time it was about 90 degrees out, and the last time it was about 62 degrees out. Just thought that the Banks Six Gun/Speed Loader only raised the fuel rail pressure to near max in 5 or 6. Kinda caught me off-guard.

Here is the deal. I found out that the code is a "Fuel Rail Pressure High" I don't know why it poped up, but after six starts without re-occurance of the problem the light goes out and the code is reset. If any of you guys are interested in a list of the codes for the 03' up trucks I have a partial list I can post.