|
geno 01-10-2004, 11:04 PM Took the K&N off and put the 11" cone UNI with sock pre filter over the cone. Tight fit but will go, I figured if the KN would flow more than the UNI I should get close to same flow with longer Uni. Had to cut the stud off the UNI to get it in the KN box. I guess I got a KUNI air filter now http://www.dieselplace.com/forum/smileys/Ermm.gif Geno easymon4u 01-11-2004, 12:10 AM What is the part # of the UNI Filter? geno 01-11-2004, 10:11 AM Easy UAP-908 Filter 01-1122 Pre Filter Go to the automitive section unifilter.com an you can looksee a photo Geno Terry 01-11-2004, 11:17 AM Sounds good. Not to hijack this topic, but what about installing a UNI Clamp-on filter (http://unifilter.com/clamp-on.htm) for the crankcase tube? Is there already a factory filter on it? Think it be worthwhile? Thanks for any insight, T. geno 01-11-2004, 11:43 AM Terry Got me , this a new one for me, I will be all over my truck today and see if I have over looked one. I haven't seen one but I was not lookin for one either. Geno YZF1R 01-11-2004, 01:04 PM OK, anyone know what the AFE pipe size is? Steve Terry 01-11-2004, 03:20 PM Terry Got me , this a new one for me, I will be all over my truck today and see if I have over looked one. I haven't seen one but I was not lookin for one either. Geno Hehh - ok. I just crawled under the nose & measured it. It's 3/4" so the smallest clamp-on would work. My reasoning is this; it's "damp" around the exit of the tube so if stuff is getting out, it's also getting IN.... YZF1R: I have the AFE, but I'm not going to remove the filter to measure the pipe - sorry... Just by looking at it, I would guess anywhere from 3.5-4". good luck, T. geno 01-11-2004, 04:41 PM YZF1R Should be 4 " but I would measure to make sure, The K&N is just over 4" and the UNI will stretch over the tube to make a snug fit, Slides on easy. Geno Never thought but Kennedy probably got these and can tell you what will fit whatEdited by: geno Terry 01-11-2004, 04:52 PM YZF1R: I have the AFE, but I'm not going to remove the filter to measure the pipe - sorry... Just by looking at it, I would guess anywhere from 3.5-4". Ok, here's the link to the AFE FAQ (http://www.afefilters.com/FAQs.asp). There appears to be several e-mail addresses there that you can send your questions to. hth, T. YZF1R 01-11-2004, 06:11 PM Thanks guys. I don't have an AFE but always wondered. JK does have AFE intake kits so he is probably a good lead. Thanks Geno. I just don't have the money to buy an AFE and then look for a UNI type filter only to find nothing that fits. I'll have to talk to JK. Looks like we may finally have a way to get turbo noise and the type of filtration that some prefer. Steve | ||