Do the bowtie molded flaps screw into the wheel wells? Where can I get these at for both the front and rear? Anyone have pics or thiers? Anyone have ANYTHING to say about these +/-?

THANKS!

My GMC flaps (splash guards) mounted using the existing holes. You just pop out the existing plastic rivits and reinstall with new ones provided.

Go to this site... http://www.gmgoodwrench.com/accessoriesjsp/home.jsp and select your vehicle. Print out the part numbers and go to your local dealer. I got the molded ones (front and back). They were $34 a pair.

If you want pictures, I can post some later. My tires were picking up stones and I cringed each time one flew up and hit the sheet metal... No chipped paint, but as hard as they hit you'd swear there would have been a dent or chip. I also installed running boards. No stone issues now.

Post # 27

Check Here (http://dieselplace.com/forum/showthread.php?t=30910)

Idahofox

Idahofox,
i like the look of those. did they come with the holes pre drilled for mounting?

Idahofox,
i like the look of those. did they come with the holes pre drilled for mounting?

Yes.

Predrilled and every thing but installed, purchased from Greg, See the bottom of my sig.

One hour, 2 beers, err. 3 BEERS, err., can't remember.

Idahofox

ok idahofox, i just ordered them from gmdieseltech. i am already ready to put them on and yet the credit card aint even made it back in the wallet yet. :D
the only bad thing about the ordering process was that i found a bunch of other stuff i NEEED, :eek: so , you guessed it, i got them coming too. i already have a reel light sitting on the kitchen table ready to install.:o: that was from the last time i went to that site :grd:

ok idahofox, i just ordered them from gmdieseltech. i am already ready to put them on and yet the credit card aint even made it back in the wallet yet. :D
the only bad thing about the ordering process was that i found a bunch of other stuff i NEEED, :eek: so , you guessed it, i got them coming too. i already have a reel light sitting on the kitchen table ready to install.:o: that was from the last time i went to that site :grd:

I hear You. ):h

Idahofox

Got the new mud flaps installed this evening, took about 45 min for all 4:cool:
real easy install on the rear, the front were a little harder with the nerf bar in the way of the bottom bolt.

also, stocked up on a new set of filters and got a WIF wrench, I think its made of aircraft aluminum :cool2:

thanks for the tip Idahofox.

thanks for the parts Eric.