I just removed my banks sixgun and bullydog stack and 4 inch exhaust all back to stock. After doing so my truck idled @ 1000 rpm for along time like 10 minutes and then went back to normal. I drove it around a bit and noticed the engine temperature gauge quit working and the service engine light came on. I pulled the code it was a 118 which says high output temperature? Has anyone experienced these problems b4? I noticed when I installed the banks my motor reved funny after I removed it. The motor makes alot of noise and doesnt run or sound right?

I had alot of problems with a six Dud stack with a Predetor, I had bad shifts ,the six gun kept blowing fault codes for to much rail presure, and would turbo bark sometimes, I think it has to do with the heavey protection built into them

Why'd you pull off all the fun stuff?

Sounds like your truck is trying to tell you somthing.
It got so mad when you took its self esteem away it overheated.):h

Ya, it ran really good, just bought a new one and kept my goodies, now I have to get this one back running again so dealer isnt pissed.

Ya, it ran really good, just bought a new one and kept my goodies, now I have to get this one back running again so dealer isnt pissed.

You took the Drugs away and now it"s having withdraws.

found the trouble it was the connectors, I had to use a wire tie to suck them together, they must be worn out, dealer told me they are only made to be taken apart about 5 times and then you have to replace the entire wiring harness, they make no replacement pins.