|
PEANUTGRWR 01-10-2004, 12:49 AM I KNOW IVE SEEN IN ON THIS BOARD SOMEWHERE BUT CANNT FIND IT--------I NEED TO KNOW HOW MUCH OIL MY ALLISON IS GOING TO HOLD WHEN ITS BONE DRY-------GONNA DO AN UPGRADE IN A FEW DAYShttp://www.dieselplace.com/forum/smileys/Big Smile.gif Mackin 01-10-2004, 01:16 AM New converter ?? Going to be completely disassembled ??Deep pan shallow ?? I needed all of 5 gallons + with a deep pan and triple lock TC ... But mine was DRY I mean DRY ... I would say have 5 gallons on hand .... If you have extra drain the T case and refill ....Don't forget to get the adapter gasket for the T case,dealer item ... Mac http://www.dieselplace.com/forum/smileys/Approve.gifEdited by: Mackin PEANUTGRWR 01-10-2004, 01:54 AM THANK FOR THE INFO-------SHOULD I NEED ANY OTHER GASKETS/SEALS FROM THE DEALER OTHER THAN THE ONE METIONED ABOVE? Mackin 01-10-2004, 09:30 AM The Transgo kit comes with the other three,assuming you've got one .... You'll need some sealant for the pump bolts in the bell housing on reassembly .... You should get a new spin on and pan suction filter .... Mac GMCSID 01-10-2004, 02:51 PM Also put copper washers under the two bottom converter housing bolts. There have been issues with case porosity causing pressurized fluid to leak into the thread area of those bolts. | ||