i had to work late today so my cousin started pulling my dash out to put in the new stepper motors and LEDs. He didnt mark the needles with tape off at where they need to be placed when reset, not cool. So how do i place them back when new steppers are in so its accurate?

also i left my meter at work and cant get it till monday so wat side of the panel should i put the resitor on?

im driving to neb in the morning so i hope someone can help me

http://www.dieselplace.com/forum/garage.php?do=view&g=20391


try that he has the positive sides marked in the bottom picture.

awesome thanks i take it red lines are pos i hope

still need help on the needles
guess ill just set them just under all the marks kinda like how the speedo sits normally?

oh and does it matter which directions the resistors go?

well got em in and they look sweet but now my batterys are dead and truck wont start. I guess with the door dinger, key on and dome light on for 10 min totally drained it.


BTW pictures do not even come close to how good these things look

trying to find a LED writup for the cargo & fog light buttons it looks like ones a 3mm, wondering if i could use a 5mm

k guys my stepper for the fuel gauge does not reset it just keeps climbing forward every time the key is turns on. Bad stepper motor maybe? Would is have something to do with a bad solder joint maybe?

gotta go to nebraska here in a bit 3hr drive cant run outa fuel someone help!

Just go by your miles to empty in your DIC till you get it figured out......

Tomorrow, I'll find the package my steppers came in the guy sent me a short letter on this. We are out camping and will be back home easter bunny day.

figured it out had to solder a jumper wire to the first terminal works good


But now my service light is on so now what. guess illtake it somewhere to read it and hope for the best