I am sure this has been asked before but I could not find it. How is this done... I currently have EFI in my truck with the DSP2 switch.

Would like to totally eliminate the hiss, is this possible?

Set your vane position tables to about 10-15% under idle conditions.

Which table should I do this in? EGR is off.... So would i do it in the "Turbo Vane Target Position, EGR Off, Low Altitude"?

Also, how high in the RPM's should I make these adjustments? And how high on the mm3 side?



Thanks

Do each of the altitudes as well as the transitions... you just want it to happen no matter what altitude you are at.

Just needs to be done from 0 to 800 RPM since idle is roughly 720RPM.

Brian

Thanks.

Also, to disable EGR, do I just open Parameters under EGR and select disable?

Thats just the monitoring... you will need to change the temps at which the solenoid operates... IE set the max engine temp to like -40.

Thanks