|
rubix 06-23-2005, 05:16 PM i would like to purchase an egt gauge how hard are they to install? Also were is a good place to purchase any recomendations on the which one to buy? i am going to run a hypertech on the lowest stage do i really even need a gauge? idahofox 06-23-2005, 05:25 PM Do a Search rubix. Idahofox kbk 06-23-2005, 08:09 PM Installation instructions here: http://dieselplace.com/forum/showthread.php?t=892&highlight=Thermocouple Reffered to as the "Hoot Method". Mark Craig 06-24-2005, 09:28 AM rubix, East install just drill tap and thread it in. We have directions as well as all the Auto Meter, & DiPriocl gauges to select from. Get yourself a boost gauge while you 're at it. It lets you know what's up with the turbo and even if your air filter is getting way too dirty etc. Mark @ DPPI rubix 06-26-2005, 10:55 PM so just to clear my simple mind a pyrometer is a egt gauge? what is a safe egt temp range briano 06-26-2005, 10:58 PM a pyrometer is the actual sensor that you tap into the manifold..the EGT gauge gets its reading from this sensor. juscruzn 06-27-2005, 12:51 PM RUBIX Check you this link. http://www.bankspower.com/Tech_whyegt.cfm Everything you wanted to know about EGT's. NICKG posted it on another thread. | ||