Just curious what most are using for a jet (single stage) with either a Edge/Quad215 stack and/or a Edge/Predator stack? Also with what level on each?

Thanks,

Eric

spraying a single stage into the intake air heater location I used a .059 - .062 jet to clean up the Quad/Edge stack

Thank you. Just trying to get a feel for what others are using.

I thought there was more room for oxide with this stack, but I guess not.

Thanks.

I haven't ran the Quad/Edge stack, but in terms of fueling it's in the same ballpark as the TTS Extreme (I think), so my results from the last DHRA event might be useful. These are with 34" BFG All-Terrains at LACR.

Jet size / 1/8m mph 1/4m mph
#2-only / 8.3sec 80.6mph 13.3sec 99.3mph
.060jet / 8.0sec 85.3mph 12.6sec 106.2mph
.080jet / 7.8sec 88.0mph 12.3sec 109.2mph
.090jet / 7.6sec 88.9mph 12.17sec 110.5mph

Hope this helps.

Doug

Doug,

First off, thanks, that does help. Second, all those times are in 4wd right? Third, do you have incremetals on those runs (ie 60', 8th time and mph, 1320 mph)? If so would you mind posting them?
Thanks.
Eric

Eric,
I'll post the info you requested tonight.

Doug

Eric,
I updated my post above with the added information.
Doug

I have an 01 duramax i just bought. It came w/ a hypertech III programmer. I plan on purchasing the "hot" juice. Can I stack w/ the edge?

Not on a stock trans........

Actually a hot juice will nuke a stock trans, over the 90HP level unloaded is probably a slow death for your trans.