I have been reading all over this site but only found older information. I am looking at at a KSH Marine Toolbox/Fuel tank. However, I read a post by Gardnerteam who had a bad experience with them back in 2004. I know...A long time ago....But....Has anyone had any experience with them lately?

I want a mill finished tank and I'm having some trouble finding one. Transfer flow does not have a mill finish tank but have they aluminized steel. Don't like it because there is not anything between the filler neck and the toolbox. Diesel overflow will run into the toolbox. Maybe that is no big deal........I don't know but I know I spew fuel out of my pissant factory tank all the time so I'm guessing I will in a toolbox also.

Any thoughts would be appreciated.