I'm replacing my 62K mile OEM shocks for a new set of Bilsteins, front and rear. My question is, what is the proper torque spec for the bolts on the front and back? I've been searching the web but cant find a real good answer. Truck is an 06 2500HD

I've never used a torque wrench on shocks. However I bet some on here can give u the info.

Ive always just tightened them down pretty tight and never had a problem

same here

As tight as you can do it by hand with a big wrench. That will be enough and then you should still be able to undo them with the air impact.

Just tighten it and it will be fine

Front shock--> top mount: tighten until bushing equals washer, bottom mount: 59ft/lbs.

Rear shock--> 70ft/lbs for top and bottom.

same here tight as I can get and off I go.