ok so i replaced my factory gauge face with an aftermarket one and now my tach, fuel and voltage gauges are off any way of getting them back to normal?? thanks

I guess you could take the needles back of and plug it in and turn on ignition and then turn it off and the stepper motors should go to zero and unplug cluster with ignition off and reinstall needles...

will try thank you

the best thing you could do at this time is get your truck to normal operating temps and pull your needles and put them back where you think they belong. its also good to have a buddys lb7 at the same temperature right next to yours and just set your needles where his are

does your banks tuner have the display like an edge or the pda display? because you cold turn that on and view your gauge readings off that to set your needles. except for your fuel of course

sadly it doesnt, but.. i just bought efi live will be installing tommorow. does that have readouts on the computer?

as far as i know yes. you should be able to pull all of gauge readings off the efi live

From tinkering with the EFI live software, I have seen different gauge readouts. So you should be able to reset the gauge arrows. Seems like u just need to manually recalibrate them.