|
anderwereld 12-03-2009, 07:41 AM hello, i just boucht a new grey stanadyne pmd, schould i mount it on the pump or is it better to relocate it out of the engine? stanadyne advises to mount it on the pump?:( BlueBurby1 12-03-2009, 08:39 AM outside the engine bay, GM recommends on the pump too :rolleyes: WI Huck 12-03-2009, 09:05 AM I just updated my web site with this information. The new PMD is made better than the old one, but that does not fix the problem of the location where all the heat is at. There is a lot of fixes out there, but where we are in Wisconsin we have had great results with our cooler that mounts to the intake manifold. The bennifit of that placement is no extra wiring is needed. Check this out http://www.hdiesel.com/product.asp?id=42 Mark JMJNet 12-03-2009, 11:01 AM pmdcable have the cable with the correct (new) connector to mount it outside. Bison 12-03-2009, 11:28 AM Old PMD cable Connector works fine on the new grey PMD once the keys are filed down same for the resistor anderwereld 12-03-2009, 05:23 PM the pmd came with a new harnas with new conectors can i cut the conector off and connect it to the old cable ,or wil this give me problems? (im planning on relocating the pmd to the grill) chevyinlinesix 12-03-2009, 06:38 PM Yes you can, just make sure you keep the wiring in order and it will be fine. Rafedial1 12-03-2009, 07:16 PM ^^+1. make sure you use highgrade oil resistant wire and good shrink style connectors. A loose connection in the PMD harness could be very bad and drive you nuts. check out what Bison said...you may not have to cut anything. | ||