|
rockinduramax 11-21-2009, 04:05 PM i've searched and cant find anything on how to take off the rear door panels. i got a set of painted handles for the exterior and cant figure out how to take the rear door panels off. i found how to take the front off but nothing on the back. can someone help me out. thanks callie454 11-21-2009, 04:35 PM http://www.dieselplace.com/forum/showpost.php?p=3542595&postcount=1 rockinduramax 11-21-2009, 07:00 PM so there are just 2 screws? makduff3 11-21-2009, 08:12 PM that is all that were holding on my Burbs rear door handles.. then the clips.. Good luck!! callie454 11-22-2009, 07:09 AM Yup, 2 screws! rockinduramax 11-22-2009, 05:39 PM ok guys new problem im changing the exterior handles. i havent tried taking the rear oanel off but the front i have. do you have to remove the window to get to the bolt for the handle??? callie454 11-22-2009, 09:23 PM No. I forget exactly which tool I used, but if I had to guess, I think it was a 10mm 1/4" swivel socket on an extension. IIRC, I removed the plugs on the door, located by the latch assembly; this gave me access to the hidden nut. It was awkward, but not impossible. The nuts are all 10mm, in case you didn't know. I believe I have the instructions lying around here somewhere, I could scan them for you if you need them. Good luck. rockinduramax 11-23-2009, 10:42 AM if you can get those instructions that'd be very helpful callie454 11-23-2009, 01:33 PM Here you go. I threw in the tailgate instructions too. Hope this helps. rockinduramax 11-23-2009, 06:50 PM sweet thanks that should help me out | ||