|
acesneights1 10-18-2009, 08:02 PM On my CUCV the wipers are slow and don't speed up on high. There is a little three capictor thingy on the side that used to go inline between the wiring harness and teh wiper motor. it's disconnected and the harness plugged into the motor. It doesn't change speeds. I tried kooing it back up, made no difference. I'm thinking the motor is toast ?? IamDave0887 10-18-2009, 09:51 PM Mine start off moving slow and then speed up to normal speed. on the blazer there's a brass "strip" that i'm guessing grounds the wiper motor. Could be an issue with that perhaps? Maybe the motor just needs to be pulled apart to be cleaned and greased? acesneights1 10-18-2009, 10:51 PM Sucks cause I know I have spare on LI. jjw565 10-19-2009, 03:42 PM Being a CUCV is the motor hoping for 24V perhaps? Jodean 10-19-2009, 03:52 PM a new motor cured my slow wipers.....never did find a delay module yet.... acesneights1 10-19-2009, 08:35 PM No. ONly the starter is 24v on the m1008. everything else is 12v. Jodean 10-19-2009, 08:59 PM the motor isnt very expensive and very easy to replace. Mine looked slow on high or low, didnt make a difference and was pulling way too much power. acesneights1 10-20-2009, 08:19 AM OK. I'll give that a shot | ||