Do any of you folks have any ideas on where to mount the Edge/EZ toggle switch? I e-mailed Edge & asked them for the demensions so I could attempt to fabricate a surround/bezel for it. They said look on their page's picture and I could figure it out. I really did not see a picture of the switch unless it is the unit in the center of the photo---not much help. I think it would look good mounted in the O'Head console in a Trippin mount next to a boost & pyro guage. Hate to cut a hole in a $135.00 mount.

The switch is a very small toggle. I fabbed a mount for it next to the e-brake handle under the dash and used one of the factory screws to secure it. It came out good, very easy to change levels and did not wreck any of the factory plastic. If I think I drilled 1/4" hole for the switch. The switch it self is about 3/8" wide and about 1" tall. Hope this info helps.
Jimmy