This seemed to be the most fitting place for me to post this... Anyways I am hoping someone can shed some light on this for me.

I need a couple measurements from a P7100, not any precise, I just need the basic external dimensions.

From mounting flange to rear-most part of pump
Overall width
Overall height

This seemed to be the most fitting place for me to post this... Anyways I am hoping someone can shed some light on this for me.

I need a couple measurements from a P7100, not any precise, I just need the basic external dimensions.

From mounting flange to rear-most part of pump
Overall width
Overall height

lol I have just asked someone on Ebay the very same question :D if and when he replies I will let you know ;)..

Adrian

Thanks :)

Here you go :D...
Overall Length 57cm
height 27cm.

I was wondering if there was another IP that could be fitted to the 6.5, one that could increase fuel in relation to boost pressure, on the Bosch rotary pumps they have a diaphram on the top that is called an Aneroid device.

One advantage to this, less fuel consumption at lower throttle, and below boost. And another is as your boost goes up so does your fuel, and as your fuel goes up so does your boost ...snowball effect , which ends up as a large power increase like a kick in the butt :D:D...

Adrian

Thanks, I actually contacted a place earlier today and got a price and some other valuable information on a similar injection pump. I just had to find someone who carried what I was looking for, and was willing to work with me on it :D

Thanks, I actually contacted a place earlier today and got a price and some other valuable information on a similar injection pump. I just had to find someone who carried what I was looking for, and was willing to work with me on it :D


Sounds interesting :rolleyes: tell all then what pump are you looking at :D

Adrian