Can anyone give me the correct procedure to installing this? Its the 4" cat delete turbo back...Its currently on the truck but I get an annoying rattle coming from the pipe that goes over the tranny crossmember. I have tried to raise it up but its not working. The next closest hanger after the crossmember is not really doin the trick, and the one after that does absolutely nothing. When I attach the clamp with the shortest exyension it is still way to long...so that hanger doesn't even get used....Any thoughts?

Thanks

I had the same problem. It was a long time ago so I dont remember what I did to fix it.

On the front pipe (cat delete) my truck had a hanger with two holes, I remember using the other hole not the original one.

Another tip is to loosen all clamps, hanger clamps and exhaust clamps. Block the exhaust up as high as you can off of the crossmember, then retighten the clamps.

I also happen to have several of the ubolt type hangers in my attic. If I have one you need consider it yours.

I had to use a 3/4 inch socket betweent he cross member and the front pipe then re tighten. that worked for me

I had to use a 3/4 inch socket betweent he cross member and the front pipe then re tighten. that worked for me

Works for me everytime.

Hey Thanks guys....I will be out there trying this afternoon...On the turbo down pipe, do I have much room for movement? I wasn't sure with that style clamp....

and thanks again I will keep you posted

Thanks