briano
05-17-2005, 10:31 AM
anyone else have the ATS overhead console mount for the Edge ***?
I just noticed the other day that it was starting to come out. I think with the heat here in texas has caused the once super tight fit to now be loose and the left side is popping out. anyone else seen that?? I can push it in and it will pop out in a few seconds.
I couldn't get this mount to install in the first place without some minor trimming of the console and now the heat made it loose and start to come out on its own.
I removed the whole thing and ended up having to drill two small holes through the plastic clips and into the top of the ATS aluminum itself, not all the way, just as pilot holes. I took two small screws and put them in and now it anchors it down and does not move at all.
I just noticed the other day that it was starting to come out. I think with the heat here in texas has caused the once super tight fit to now be loose and the left side is popping out. anyone else seen that?? I can push it in and it will pop out in a few seconds.
I couldn't get this mount to install in the first place without some minor trimming of the console and now the heat made it loose and start to come out on its own.
I removed the whole thing and ended up having to drill two small holes through the plastic clips and into the top of the ATS aluminum itself, not all the way, just as pilot holes. I took two small screws and put them in and now it anchors it down and does not move at all.