Is it like the PML and doesn't come drilled and tapped like the Mag Hytec for a gauge sender?

Mackin`, are you getting the 5 or the extreme?

wayne

I believe that it says STAGE V in his signature.

ATS cast pan is wicked, very heavy and solid. My only grip is the drain hole is way to big. Hard to drain the fluid and catch it when doing minor adjustments. Other then thats, its pretty cool.. I dont recall seeing a spot for a gauge in it, but didnt really look for one either.

I kinda like the good old tin pan. Much easier to work with.

PML has the best drain valve positioning,only it's on the wrong end...

The ATS pan is so huge I am afraid a might be a heat sink.

I think I'm going to drill it and tap and sell the Mag Hytec and possibly my deep an too which is bunged for a temp sender and stick with the ATS.

Going to decide when it arrives

I haven't seen the inside of the ATS pan, but the Mag Hytec has a nifty little rib designed to keep the filter from falling out. Problem is, the filter is getting worn into by this rib.:wtf1:

I'll let you know if mine is scraping on the ribs.