a stock lmm with 3.73 gears and stock tires
what should each gear top out at for MPH?

When it shifts? Is that a trick question?

I say a lot of that depend on transmission and engine temperature, tow/haul mode, rpm, speed you are going. You can goto this site and play around with numbers to see speed to rpm for each gear. But top stock speed is around 94mph. Just the speed limiter setting. But got this site and setup the transmission and figure top rev limit of 3250 rpm and see what mph you be going. http://www.grimmjeeper.com/gears.html

Brian

I'm pretty sure he is asking if you put it in M1 and floored it what MPH would it be at when it is on the rev limiter, same for M2, M3, etc.

3rd is 58 with a headwind, 62 tailwind TC unlocked.

I'm pretty sure he is asking if you put it in M1 and floored it what MPH would it be at when it is on the rev limiter, same for M2, M3, etc.

Yea sorry guys I was pretty sick when I posted that and after reading it again realized I wasn't too clear.

What ryan said is what I meant. WOT top of each gear

Thanks for the link Tanc

try it and find out haha

I'm pretty sure he is asking if you put it in M1 and floored it what MPH would it be at when it is on the rev limiter, same for M2, M3, etc.


The truck would shift from M1 to M2 and so on by itself then?

:eek:

The truck would shift from M1 to M2 and so on by itself then?

:eek:

No it won't, not if it is in manual.

totally warm everything up, put it in m1, take off. somewhere around 3300-3500 you will top off, make a note of your speed, goto m2. wash, rinse, repeat.

not sher on 1,2,3, but on the dyno 4th was like 107 but thats at 4200rpm and 5th was 155mph at 4200rpm don't no if this helps?..haha