I tried my LB7 shaft but it's too small. I twisted my shaft pulling and it was suppose to be done today but it wasn't and I need to take my truck on Monday to get some work done.

If its not that far away, just lock er in 4wheel drive and be gentle getting her to the shop.

If its not that far away, just lock er in 4wheel drive and be gentle getting her to the shop.
It's a 5 hour drive, if it was 30 min I would do it. Thanks though.

Talked to me dealer this morning and apparently they switched to bigger universals on the NBS trucks. So driveshafts are not compatible.

Sorry man, i guess you need to go kick your driveshaft guy in the behind. I checked the listings and there doesnt seem to be a conversion joint to adapt 1485 series( what you have) to 1410 series (what the lb7 has), which would get you out of pinch if the slip yoke fits in the transfer case.