How does the attitude attach to the A pillar mount? Does it screw or is there some way it sticks to it?

It comes with a very cheesy little metal arm that uses double sided tape to both the attitude and the a pillar. Wobbles on the freeway and when hot outside, will fly off the a pillar when a button is pushed or when left outside for a length of time. I highly recommend spending a few bucks (think I spent about 50 including paint) on a more stable mount. A lot of the supporting vendors carry them.

Vegas thanks for the quick response. I do not want the mount that goes in the cubby above because I use teh space. What do you recommend?

i have the pillar with attitude mount, just fits over the existing one

I bought a sheet metal mounting plate that fits over the opening that is to the right of the radio/heat controls. I'll have to see if I can find his name. I left my ISSPRO guage mounted behind it for those trips to the dealer. I also didn't want to remove or relocate the guage until I am sure I like the location for the Attidude. So far, so good.:D

Here's a link to RickDLance's post about the mounts. I do like it. Simple and inexpensive.

http://dieselplace.com/forum/showthread.php?t=22227&highlight=Attitude+Mount

I used velcro. look here http://www.dieselplace.com/forum/attachment.php?attachmentid=2309

homehandyman,

We have full A pillars that snap over the existing A pillar, no holes required etc that mounts the Attitude perfectly. They are black and we also have the matching paints and special plastic primers to make it look like a stock factory part.

Mark @ DPPI