On the rear left side of the motor there are 3 solenoids, two lines run to the front one goes to the turbo the other one goes somewhere up there but it is hooked up. There is also a short one that goes to the egr and then a chunk of hose that I can not figure out where to put, any help would be great I am getting ready to start the truck tonight after having the motor tore apart. :help:

If you have an egr you should also have a sensor mounted to the firewall that looks just like the map sensor on the intake plenum. That hose connects to the barb fitting under the sensor. Good luck fireing it up!

Thanks, after I left the message I looked at the emmisions hose routing sticker and found where to go, still haven't got to start it yet, Censored hopefully tonight.