jdes
05-20-2009, 09:23 PM
Hello to all you brainiacs out there. I had trans rebuilt, all new avail update parts were put in. New billet convert. transgo programer.
Finally got around to installing it in truck.
No forward or reverse. Feel it engage, but slips in both ranges. Do have 1st gear low in manual shift setting.
Dropped pan found what appeared to be more metal particles than I would suspect in new trans run 15 minutes.
Did find a wire broken at transfer case, believe it might be VVS. Would this create my issue. Still thinking too much shinny metal bits in fluid might be something else.
Guy that rebuilt it doing 6 months in county. Go fiqure.
Any ideas greatly appreciated.
Finally got around to installing it in truck.
No forward or reverse. Feel it engage, but slips in both ranges. Do have 1st gear low in manual shift setting.
Dropped pan found what appeared to be more metal particles than I would suspect in new trans run 15 minutes.
Did find a wire broken at transfer case, believe it might be VVS. Would this create my issue. Still thinking too much shinny metal bits in fluid might be something else.
Guy that rebuilt it doing 6 months in county. Go fiqure.
Any ideas greatly appreciated.